Electrical fire arc test machine Simulate the ignition process caused by electric circuit arc and the cause of fire formation.
Electrical fire arc test machine Simulate the ignition process caused by electric circuit arc and the cause of fire formation.
Comply with ISO 11601:2017,It is suitable for the driving performance test of the trolley fire extinguisher.
Suitable for industrial and commercial use flammable gas detectors, home combatant gas detectors, industrial and commercial use portable combustible gas detectors, household and small catering kitchen gas alarm and sensor, household gas alarm, the functional tests of the sensor, and functional tests at high, low temperature, damp heat environment;
It is an independent smoke alarm fire detection, a dot-type fireworks detector, and is suitable for various functional detection of alarm device installed in civil buildings.
This Hydraulic Pressure Comprehensive Testing Machine is suitable for fire hose test with hose specifications of 25, 40, 50, 65, 80, 100, 125, 150, 200.
Suitable for industrial and commercial use point type combustible gas detectors, household combustible gas detectors, industrial and commercial portable combustible gas detectors, household and small catering kitchen gas alarms and sensors, household gas alarms and sensors. functional tests in high and low temperature, humid and hot environments;
It is suitable for fire coupling drop test.Install the sample on the test bench so that the distance from the lowest point of the sample to the base is (1.5±0.05)m. After the sample is stationary, let it fall freely on the base. Check the sample for damage.
It is suitable for fire-fighting soft reel and fire-fighting water gun spray test.This equipment only includes fire hose reel jet test, fire water gun jet test and flow test;
This Hydraulic Pressure Test Machine For Fire Extinguisher is suitable for water pressure sealing and strength test of sprinkler.
Compliant with ISO 2592 standards It is suitable for the determination of flash and fire points of petroleum products by the Cleveland open cup method. Flash point and fire point are used to evaluate the flammability and combustibility of substances.
This Automatic Pensky Martens Closed Cup Flash Point Tester Comply with ISO 2719-2016 and ASTM D93-2018 standards,It is suitable for determining the flash point of flammable liquids, liquids with suspended particles, liquids whose surface tends to form a film under test conditions, and other liquids by the Pensky-Martin closed cup method.
It is suitable for the drop test of the flammable gas detector.The mass is ≥2kg, the drop height is 1000mm; the mass is greater than 2kg and not greater than 5kg, and the drop height is 500mm;
It is suitable for impact resistance test of fire hose reel.Impact hammer: 25kg;Load hammer: 80kg;
Load performance test of fire hose reel: fasten the fire hose reel on the impact test frame, the hose reel is in a horizontal position, and use a thin wire rope to hang a weight of 80kg on the wheel of the outer disk wheel. On the edge, after 72 hours of static, do the impact test again to see if it meets the test requirements.
WhatsApp:
Mobile Phone:
Contact Now
