Optical Cable Repeated Bending Testing Machine

What is the Optical Cable Repeated Bending Testing Machine？

Optical Cable Repeated Bending Tester is suitable for determining the ability of optical cables to withstand repeated bending. The test equipment can make the sample bear the tensile load and at the same time bend 90° to the left and right sides of the plumb line. This does not include the attenuation detection part.

Compliance:Comply with IEC 60794-1-2: 2003 "Optical fiber cable — Part1-2: Generic specification — Basic optical cable test procedures"

Main features:

1. PLC, touch screen display:

2. Test conditions: test speed, test times, control conditions, etc.;

3. Test monitoring: the current equipment operating status, such as the actual number and speed of cable bending;

4. Special fixture: According to the cables of different wire diameters, there are corresponding bending curvature rollers to adjust the bending curvature radius;

3.5 Machine performance: using touch screen + PLC + motor, the transmission parts are all imported products, stable operation, large torque, high positioning accuracy, long service life, low noise;

4. Technical parameters:

4.1. Test station: 3 stations

4.2. Test method: the upper end is fixed, the lower end is suspended with a counterweight, and the sample is bent through a freely rotating bending curvature roller;

4.3. Sample diameter: Ф1～Ф10mm

4.4. Bending point curvature rolling axis: Ф5, Ф10, Ф20, Ф30, Ф50mm can be replaced

4.5. Sample speed: 30 times/min;

4.6. Bending angle: ±90°;

4.7. Control method: touch screen control

4.8. Machine material: main part: 45# high-quality steel and aluminum structure;

4.9. Power and transmission: Servo motor is used;

4.10. Rolling shaft for testing bending point curvature: 45# high-quality steel, chrome-plated surface

4.13. Motor power: 1.5kW

4.14. Machine size: W1850*D800*H1700mm (including caster height)

4.15. Power supply: 220V50/60Hz 10A